Jeep JK Rear Bumper
Scroll down for pricing and options.
The ShrockWorks Jeep JK rear bumper was designed in 3D CAD and is CNC cut and formed for a perfect fit, every time. The main shell of the bumper is made from 3/16" HRP&O plate steel with 1" plate for the recovery tabs to keep the shackle from flopping around. The recovery tabs are slid through from the inside and then welded front and back to avoid pulling through. On the inside, they're welded to the frame brackets which means you're pulling on the frame instead of the face of
the bumper. Available in both a Stubby and Full Width. The Stubby comes to the edge of the sheet metal where as the Full Width extends all the way to the end of the plastic fender flare.
Our bumper utilizes the factory receiver hitch. The factory hitch sits right under the rear frame cross member, is very strong, removable, and a lot of people already have it. An integrated hitch would mean raising the tire about 3” from where we put it, the inability to run a decent sized tire without a swing out tire carrier and also would mean very little rear visibility with a big tire. If you're a hard-core guy, just leave the hitch off. Even if you leave it on, you may drag it sometimes, but it won’t hold you up, and it’s strong enough that you won’t damage it. We would rather grind and beat up a removable receiver hitch than the actual bumper. The bumper is then finished in your choice of several show quality power coats or shipped bare steel.
- 3/16" HRP&O plate steel shell
- 1" recovery tabs
- Cut-outs for 2" x 5" reverse lights
- Accomodate up to a 35" tire in the stock location
- Several powder coat finishes or bare steel
- Stubby or Full Width
- Halogen or LED reverse lights
- Two 3/4" clevis shackles
Individually handmade to order
by skilled craftsman in Houston, TX,